Replacement 3d printed feet for the Node 804, designed to snap into the stock foot brackets - the same ones Fractal glued their rubber feet into.
Why I made these:
The stock rubber feet are too short. On a hard surface, the dust filter tab touches the table and can rattle. On carpet, it's worse - the bottom of the case sinks into the carpet and chokes off airflow to the case fans and PSU fans.Two heights available:Standard (12.5mm): for use on a desk/table (hard, flat surfaces)Tall (22.5mm): extra clearance for carpet. They make the case look a bit goofy on a hard surface, they're only really recommended for use on medium/high shag carpet.
Optional add-on:
Both versions accept press-in rubber feet for an additional ~5mm of height. Since the printed feet are plastic, these add the height, anti-slip grip, as well as some vibration dampening.Compatibility: Fits the stock Fractal Design Node 804 foot brackets - no modification needed. Just remove the old rubber feet and press these into the brackets and screw into the case.
Sold as a set of 4, with longer screws included.