This is a Portable Program Transfer Device that transfers CNC machine programs from a standard USB flash drive (Thumb Drive, Pen Drive, memory stick?) to or from the CNC control through the RS232 communications port, also referred to as Drip feed DNC or Up-Loading & Down-Loading. Extension of file name supports: *.?NC, *.TXT,*.NC, *tapReplace PC running a DNC softwareThe MICRO DNC 2D is a prototype of the MICRO DNC 2C with a redesigned aluminum case and flexible plastic keyboard. The software inside still uses the firmware of MICRO DNC 2C. So basically MICRO DNC 2D and MICRO DNC 2C are the same(call them DNC 2)
function

• 3D program simulation
• Copy programs from PC to DNC 2 via wifi network,or via USB memory card
• Run the program or send a notification to DNC 2 from the computer via WIFI network
• Create or edit programs directly on DNC devices
• cut program by% or G CODE LINE Nxxxx
• transfer program into CNC machine memory
• transmit DNC drip program (works in TAPE mode)
• receive program or PC / PARAMETER from CNC machine
• with 2-4GB internal memory, USB reader support with large capacity
• has RS232 DP9 communication port
• There are 3 rear mounted magnets of the device that make it easy to put DNC on CNC machines
• LCD COLOG 3 INH
• PACKAGE INCLUDES 1DNC + 1 CABLE + 1 ADAPTER
• NOTE:You can power the DNC ONE via CABLE RS232, PIN 25 = 24V .If on the 25 pin of RS232 on the CNC machine with power(24VDC) you can not use 12vdc adapter
•