Locate the rack and pinion bellow, which is usually located underneath the steering wheel, where it connects to the steering column and steering gear

Using a wrench to unscrew the bolts, remove the steering wheel

Pulling down the dust cover. If it is stuck, try gently pushing it in one direction

Slide the new dust cover over the steering column, using tie wraps and clamps to secure the both end

Return the steering wheel to its original position and tighten the security bolts with a wrench

Finally, start the vehicle and test the steering system

• Adjustable ID Design: Our tie rod boot has been upgraded in both appearance and caliber, featuring 2 sizes on the top and 4 sizes on the bottom. The bottom calibers have been enlarged for wider compatibility with various vehicle, making installation easier and quicker
• Product Sizes: This tie rod boot measures 8.66" in total length. Top calibers is 0.62" 0.75", and bottom calibers is 1.66" 2.15" 2.51" 2.69". Both ends can be cut to fit your actual needs, simply trim to the required caliber. Note that cutting the product will shorten its overall length
• Dust Proof: The tie rod boot kit avoids wear of the rack, pinion and other steering components due to dust, sand, water from intruding into your car's steering system interior, improves the system reliability, reducing steering vibration
• Whole Set of Accessories: Our car rack and pinion boot kit is equipped with 2*tie rod boot, 6*cable ties, 2*adjustable small bellows locking clamps, 2* big adjustable bellows locking clamps, full set of accessories, you can install it when you get it
• Easy to Install: Simply remove the old kit, clean the surface of the steering rack, put the new steering rack boot on the rack, keep it completely cover the part needs to be protected, use the provided cable ties and Locking clamps to fix the both end