This KVM switch will let you use three(3) monitors plus other USB peripherals between up to two(2) computers.

NOTE: If you're planning to use 3 displays with a laptop, make sure your laptop actually supports 3 displays!

How our KVMs are different:

Most of the time KVM switches are meant to work with servers, and basic mice and keyboards.

Our KVMs:

• will work with USB 3.0 (USB 3 5gbps, or USB 3.2 gen 1) peripherals as well as USB 2.0 HID-type devices.

• tested to work with high-end RGB gaming keyboards like keyboards from Corsair*, Cougar and more.

• tested with keyboards that have built-in USB hubs as well as USB pass-through.

*See the ‘Additional Info’ section for extra details regarding the use of Corsair keyboards.

Features:

• Full DisplayPort switching capabilities

• One DP 1.4 connection from each computer (up to 4k/120hz or 8k/30hz).

• Lower resolutions + Higher frame rates possible e.g. 144hz @ 1440p (Overclocking not supported)

• DisplayStream Compression Supported

• Intelligent EDID Engine for HDCP Re-keying (computers know when the port is inactive. Check out the Level1Techs repeater if you need monitor emulation).

• HDCP Pass-through Supported (maintains HDCP signal integrity)

• Intelligent USB HID pass-through (includes work-around for known problematic devices)

Rear:

Inputs:

• 2x 3.5mm Audio (may need a ground loop isolator)

• 6x DisplayPort 1.4

• 2x USB C USB 3.2 gen 2 Data Only Inputs [10gbps model]

Outputs:

• 3x DisplayPort 4 connection

• 3x USB 2.0 Ports

• 1x USB 3.2 Gen 1

• 1x analog 3.5mm audio

Front:

• Push button for switching Inputs

• 1x USB 2.0 HID port

• 1x USB 3.0 "A" type (USB 3 10gbps, or USB 3.2 gen 2) ports (up to 1A current) [10gbps model]