Filament compatibility

Attributes:
+ Scratchproof, hard to damage
+ Transfers texture to prints
+ More forgiving Live Adjust Z setting
+ No need for glue stick for PETG
+ Prints automatically detach after sheet cools down
+ First layer can be more squished compared to smooth sheets

- Acetone causes the surface to quickly deteriorate
- PLA prints with a small contact area may need a brim
- PLA prints with a huge footprint may warp
- Need to change Live Adjust Z if you also own Smooth PEI sheet

WARNING
Never clean the powder-coated spring steel sheet with acetone! Doing so will create microfractures in the texture, which will make the surface deteriorate over time. Learn more about printing on the Satin powder-coated steel sheet in the Prusa knowledge base .

Note:
Consumable parts, such as PEI sheets (smooth, textured, etc.) are not covered by warranty as the coatings are designed to diminish over time unless failure has occurred due to a defect in materials or workmanship. Cosmetic damage, including but not limited to scratches, dents, cracks or other cosmetic damage is also not covered by the warranty. Only defective sheets on arrival are covered by warranty.

Fits:
Prusa CORE One L